RTD-15.1 Full height rotor turnstile for indoor and outdoor application

Delivery set:

• turnstile with built-in electronics
• RC-panel
• protective canopy (optional)
• foundation frame (optional)

RTD-15 Full height rotor turnstile is designed for access control at facilities with increased security requirements and the need for complete overlap of passage zone. It is possible to operate the turnstile in the lock-chamber mode.

This series of turnstiles can be used both inside buildings and as part of perimeter security systems.

Corrosion resistance and increased rigidity of the welded aluminum structure provide vandal-proof characteristics, high reliability, and long-term outdoor use.

To simplify and improve the installation quality, the RF01 foundation frame is provided. The additional foundation frame allows installing the turnstile even on unstable ground.

The turnstile is equipped with built-in LED passage permission and denial indicators. Additional outputs for connecting remote indicators are provided.

The RTD-15 series turnstile can operate as a stand-alone unit from RC-panel or WRC or as a part of an access control system (ACS). The turnstile operation modes are controlled independently for each passage direction.

The turnstile also features:

• walkway downlights for each passage zone, LED indicators built into the top channel
• blocking of the reverse rotation when turning the rotor at more than 60° angle
• automatic unblocking of the rotors by the Fire Alarm emergency signal

If necessary (for instance, upon power failure), two built-in mechanical locks (for each passage direction) allow quickly opening the turnstile with the key.

The turnstiles can operate in two operation modes: pulse and potential. Galvanic decoupling of the turnstile outputs from an ACS controller is provided.

The low power consumption for the turnstile allows using a safety voltage.

The turnstile can also be completed with a full height gate with electromechanical lock and railing systems, produced in the same design.

The canopy protects the turnstile against precipitation and climbing over the turnstile. The canopy and the turnstile form a single construction.

Several RTD-15 turnstiles with canopies can be mounted in one row. Special couplings have been designed to provide reliable joining of two or more canopies. This design also allows laying cable through all the top channels of the turnstiles, which considerably simplifies the installation.